#1 Graphic Design and Installation in Dallas-Fort Worth

Custom Banners and Flags in McKinney, TX

Grand opening. Now hiring. Under new management. Homecoming. Sale ends Sunday. Some messages need to be twelve feet wide, and they need to be up by Thursday.

iCandy Grafix prints banners and flags in our own shop in Anna, TX, and most standard orders leave in 2 to 5 business days. Hemmed, grommeted, laminated where it matters, and priced so a small business in McKinney or Melissa can afford to change the message when the promotion changes rather than leaving a faded banner up for two years because replacing it feels expensive.

Every banner and flag we produce

Outdoor Vinyl Banners

Where it goes: Buildings, fences, events

Realistic outdoor life: 2 to 3 years laminated

Indoor Vinyl Banners

Where it goes: Gyms, lobbies, halls

Realistic outdoor life: Indefinite indoors

Mesh Banners

Where it goes: Chain link, scaffolding, windy sites

Realistic outdoor life: 2 to 3 years

Pole Banners

Where it goes: Light poles, main streets, campuses

Realistic outdoor life: 1 to 2 years

Fabric Banners

Where it goes: Stages, indoor events, photography

Realistic outdoor life: Indoor use

Feather / Teardrop Flags

Where it goes: Roadside, parking lots, events

Realistic outdoor life: 6 to 18 months

Rectangle Flags

Where it goes: Entrances, dealerships, storefronts

Realistic outdoor life: 6 to 18 months

Choosing the right banner material

Most people order “a banner” without realising there are four quite different products behind that word, and picking the wrong one is the difference between three years of service and one torn banner in the parking lot after a March storm.

13oz scrim vinyl

The default, and the correct answer for the large majority of jobs. Scrim means a polyester mesh reinforcement running through the vinyl, which is what stops a banner from tearing from a grommet under load. Tough, prints well, folds without cracking, and is economical.

18oz blockout vinyl

Heavier, with an opaque grey core layer. Used specifically for double-sided banners, because without that opaque core, the print on the back ghosts through to the front, and both sides look muddy. If someone quotes you a double-sided banner on 13oz, ask why.

Mesh vinyl

Perforated, roughly 30 percent open. The only sensible choice is anything on a chain-link fence or a building face where wind is a factor. Covered in detail on our mesh banners page.

Smooth indoor vinyl

No scrim weave, matte surface, no light reflection. For anything indoors that will be photographed or lit hard, which is most gym and event banners. See indoor vinyl banners.

Polyester fabric

Soft finish, no glare, folds into a bag rather than needing a tube. Indoor use and travelling displays. See fabric banners.

Lamination, and why we include it as standard outdoors

An unlaminated 13oz vinyl banner in full North Texas sun starts showing visible fade at around eight months. Reds and blues go first. By eighteen months, it looks tired, and by two years, most clients have replaced it.

The same banner with a UV overlaminate holds up for two to three years, and often longer if it comes down between seasons.

The laminate adds a small percentage to the banner cost and roughly doubles or triples its working life. We include it in outdoor work as standard rather than offering it as an upsell, because quoting an unlaminated banner against a competitor’s unlaminated banner and letting the client find out in year one is not a business we want to run.

Hemming, grommets, and how the banner will actually hang

Every outdoor banner from iCandy Grafix is welded and hemmed on all four sides with brass grommets set into the hem. Where those grommets go depends entirely on where the banner is going, so tell us at the order stage.

Ochain-linklink fence

Grommets every 24 inches, attached with zip ties rather than wire, since wire cuts into the hem over time. Use mesh if the fence is in open ground.

On a building wall

Grommets in all four corners plus mid-span along the top and bottom, fixed with screws and washers into the substrate. Never hang a wall banner from two corners only, because the wind load concentrates on those two points and tears them out.

Strung between two poles

Pole pockets sewn top and bottom rather than grommets, with a rigid dowel or conduit through each pocket. This keeps the banner flat instead of letting it twist.

Hanging indoors

Corner grommets are usually enough, or a top pole pocket for a cleaner look with no visible hardware.

On wind slits

People ask for these constantly and they do very little. Cutting horizontal slits in solid vinyl does not meaningfully reduce wind load, and it does weaken the banner along the cut lines. If wind is the problem, the answer is mesh, not slits in solid vinyl. We will say so rather than cut them and charge for it.

Where we work

Local collection is welcome, and we ship anywhere in the US.

Frequently asked questions about banners and flags

A custom 3×6 outdoor vinyl banner typically costs $85 to $140, and a 4×8 runs $140 to $220 at iCandy Grafix, including hemming, grommets, and lamination. Price depends on material, single or double sided and quantity, and most standard banners are quoted the same business day.

Banners take 2 to 5 business days after proof approval at iCandy Grafix. If your deadline sits inside that window, call (972) 961-3275 and we will tell you honestly whether it fits the production schedule rather than promising and missing.

A laminated 13oz vinyl banner lasts 2 to 3 years in North Texas sun. Without lamination, expect visible fading from around eight months. iCandy Grafix laminates outdoor banners as standard because the small added cost more than doubles the working life of the print.

Mesh is the best material for a chain-link fence because roughly 30 percent of wind passes through it, which dramatically reduces the load that tears grommets out. iCandy Grafix recommends mesh for any fence or scaffolding installation lasting longer than a weekend.

Yes. iCandy Grafix prints double-sided banners on 18oz blockout vinyl, which has an opaque core so neither side ghosts through the other. This is the correct choice wherever people approach the banner from both directions.

No. iCandy Grafix designs banner artwork from scratch, vectorizes low-resolution logos, and prints supplied print-ready files. Design typically adds 1 to 5 days, depending on how many revision rounds you want.

Yes, if they are stored properly. Roll them with the print facing outward rather than folding them, and keep them somewhere dry and out of direct sun. Folded banners develop permanent crease lines, and the ink can crack along the fold.

Order your banner

Tell us the size, where it is going, and when you need it. Artwork helps but is not required.

Ready to take your Advertising anywhere you go? Call iCandy Grafix Today!